• Custom fit mould to disguise crooked, stained, missing and gapped teeth
• For adult use only
• For cosmetic purposes only
• This is a temporary solution
• Two sets will be needed if both upper and lower teeth have to be covered
• Dimensions: 9cm (W) x 9cm (L) x 2cm (H)
• Contents:
  • Case
  • Teeth impression cover (if needed)
  • Silicone mouldable strip

Note: The ‘‘silicone strip’’ is the veneer that needs to be modelled to the teeth, not the ‘‘plastic teeth’’. The ‘‘plastic teeth’’ are just an impression mould. There is no need to use the ‘‘plastic teeth’’ mould. The ‘silicone strip’’ can be moulded to the teeth in the same way a gum shield is.

How to use

Method One

• Place the silicone mould strip into a cup/bowl of boiled water for between 30 to 60 seconds or until the white silicone strip turns clear
• Position the clear mould over the existing teeth
• Press the clear silicone impression material with fingers and thumbs
• Use own fingernail to imprint the lines of the teeth into the clear mould or try using the plastic teeth to get an impression
• Trial and error approach is needed, good result will require time and patience
• Gently ease the teeth out of the mouth after five minutes or sometimes longer
• Drying and setting times vary
• Place them in a glass of cold water to cool or leave to dry naturally
• The silicone strip impression material turns white when it hardens and can be remoulded as often as it needed, this will be a trial and error process
• The impression is now moulded to the shape of the teeth, can be used as desired, and can click into place

Method Two

• Place the silicone strip inside the ‘‘plastic teeth’’ and place it into a cup of hot (almost boiling) water for one minute, this will make them flexible and ready to custom fit
• Firmly position the ‘‘plastic teeth’’ with ‘‘silicone mould’’ inside, over existing teeth
• Press them firmly against the teeth and gently pat the impression material with thumbs behind the real teeth
• Gently ease the ‘‘plastic teeth’’ with ‘‘silicone strip’’ out of the mouth and after 30 seconds, set them in a glass of cold water to cool
• The impression material turns white when it is hardened
• The impression is now moulded to the shape of the teeth and can be used as desired
• Can be remoulded as many times as needed